Yb:CaF2–YF3 transparent ceramics ultrafast laser at dual gain lines

Yb³⁺:CaF₂-YF₃ transparent ceramics with excellent optical quality was successfully fabricated by hot-pressed method. Pulsed laser properties of this ceramics were investigated for the first time. Laser diode (LD) was applied as the pump source to generate a dual-wavelength mode-locked (ML) laser. The maximum average output power was 310 mW, which represents the highest output power of ultrafast calcium fluoride ceramic laser. The spectrum separated at 1048.9 nm and 1049.7 nm with a total pulse duration of 8.9 ps. The interval period between the beating signals was about 4.3 ps, corresponding to a 0.23 THz beat pulse repetition rate. These results demonstrate its potential in producing dual-wavelength ultrashort pulses. These Yb³⁺:CaF₂-YF₃ ceramics with low-cost and short-preparation period are ideal candidate materials for ultrafast lasers.     

高速线性光采样用被动锁模光纤激光器重复频率优化

线性光采样是一种测量基于先进调制码型的高速光信号的有效手段, 而被动锁模光纤激光器是其实施所需的关键组件. 本文在介绍线性光采样工作原理的基础上, 首次分析得到被动锁模光纤激光器重复频率与待测信号光线宽的约束关系, 对于正交相移键控(QPSK)信号, 当信号光线宽与采样光脉冲重复频率的比值小于1.5×10^-3 时, 高速信号的相位噪声对线性光采样带来的损伤可以忽略不计. 利用95.984 MHz重复频率的被动锁模光纤激光器对线宽为100 kHz速率为28 Gbaud的QPSK信号开展相关实验, 通过标准数字相干接收算法可以得到与传统高速示波器相同的星座图, 理论分析与实验结果完全符合. 这一研究结果有助于线性光采样用被动锁模光纤激光器的优化设计.     

QCW diode-pumped 654 W AO Q-switched Nd:YAG rod oscillator-amplifier laser

A diode laser-pumped acoustic-optic Q-switched Nd:YAG master-oscillator power amplifier laser is presented. The laser is quasi continuously pumped at 1.1 kHz with a pulse width of 172 μs, and the ultrasonic frequency of the AO Q-switcher is set at a higher value (53 kHz). The master oscillator is designed as a thermally near-unstable-resonator, which presents an average output power of 48 W with a beam quality value of M² = 1.41 and a Q-switching pulse duration of 121 ns. The maximum average power of the MOPA system is 654 W, and the beam quality is M² = 6.     

Cr4+:YAG被动调Q激光器输出特性

采用理论与实验相结合的方法研究了激光二极管阵列泵浦的Cr4+:YAG被动调Q Nd:YAG激光器的输出特性.重点分析了调Q晶体小信号透过率和反射镜的反射率对激光器的输出能量、脉冲宽度的影响.对数值模拟结果进行了实验验证,数值计算与实验结果基本一致.研究结果表明,在特定的激光晶体参数下,Cr4+:YAG被动调Q激光器的输出能量与脉冲宽度由调Q晶体的小信号透过率和输出镜的反射率决定:输出能量随着小信号透过率增加而减小,对应于一个调Q晶体透过率,有一个最佳反射率使输出能量最大;脉冲宽度随着初始透过率与反射率的增大而增大.     

100 W全光纤声光调Q光纤激光器实验研究

 报道了一台全光纤结构主振荡功率放大(MOPA)型掺镱脉冲光纤激光器,以光纤光栅为腔镜,光纤型声光调Q的光纤激光器为种子源,通过两级掺镱双包层光纤放大器实现功率放大。对声光调Q的光纤激光器输出特性进行了研究,比较了不同泵浦波长、不同重复频率对激光输出功率和脉冲宽度的影响,并实现了最短脉冲宽度25 ns、单脉冲能量45 μJ的脉冲激光输出。在重复频率50 kHz时,对脉冲宽度130 ns、平均功率0.6 W的种子光进行放大,得到了平均功率102.5 W、脉冲宽度约240 ns的激光输出。     

LD泵浦Nd∶GdVO4/GaAs被动调Q激光器研究

报道了采用大功率半导体激光器端面泵浦Nd∶GdVO4晶体,利用GaAs晶片兼作饱和吸收被动调Q元件和输出耦合镜,实现了1.06 μm激光的被动调Q运转.在泵浦功率为13.9 W时,获得最高平均输出功率为3.6 W,脉冲宽度为252 ns,单脉冲能量为27 μJ以及峰值功率为107 W的激光脉冲.     

1.5-MHz repetition rate passively Q-switched Nd:YVO_4 laser based on WS_2 saturable absorber

A transmission-type tungsten disulfide(WS_2)-based saturable absorber(SA) is fabricated and applied to passively Q-switched Nd:YVO_4 laser.The WS_2 nanosheets are deposited on a quartz substrate by the vertical evaporation method.By inserting the WS2 SA into the plano-concave laser cavity,we achieve 153-ns pulses with an average output power of1.19 W at 1064 nm.To the best of our knowledge,both of them are the best results among those obtained by the Q-switched solid-state lasers with WS_2-based absorbers.The repetition rate ranges from 1.176 MHz to 1.578 MHz.As far as we know,it is the first time that MHz level Q-switched pulses have been generated in all solid state lasers based on low-dimensional materials so far.     

光纤激光泵浦周期极化晶体双波段激光器

针对激光定向干扰系统要求对抗1 m ~3 m和3 m ~5 m 2种类型探测器,需要输出相应2种波段激光,通过高重频调Q技术和种子注入光放大技术,获得高功率高光束质量1.06 m光纤激光输出,外置起偏器获得2束激光输出,分别为泵浦周期极化钽酸锂和周期极化铌酸锂晶体,实现高功率1 m ~3 m 和3 m ~5 m激光输出。在电源输入电流60 A,调Q驱动频率50 kHz的条件下,获得最高功率7.5 W的2 m激光和4.2 W的3.9 m激光,频率转换效率为39.5%。实验结果表明:通过光纤激光器泵浦光参量振荡器,可获得高功率1 m ~3 m和3 m ~5 m双波段激光输出。     

基于SESAM被动调Q的激光二极管泵浦Yb∶CaYAlO_4脉冲激光器

采用发射波长约为976 nm的半导体激光器作为泵浦源,Yb~(3+)掺杂浓度为1. 5at.%、通光长度为2 mm的Yb∶CaYAlO_4晶体作为增益介质,本文提出了一种基于半导体可饱和吸收镜(SESAM)被动调Q的激光二极管泵浦Yb∶CaYAlO_4以获取稳定脉冲输出的方案。通过合理设计谐振腔,实现了稳定的被动调Q激光脉冲输出,并分析了泵浦功率的大小对输出脉冲的重复频率、脉冲宽度、单脉冲能量以及脉冲峰值功率的影响。